Oxygen Sensor Upstream or Downstream 01-17 Jeep Wrangler 2.4L/2.5L/3.6L/3.8L/4.0L 04-10 Chrysler Sebring 2.4L/2.7L/3.0L/3.5L
Replace your downstream oxygen sensor with this compatible oxygen sensor.
This sensor is responsible for monitoring the exhaust gases and ensuring optimal fuel efficiency and emissions control.
With a direct fit and high-quality construction, this downstream oxygen sensor is a reliable choice to maintain the performance of your Chevrolet vehicle.
Features
- High-Quality Sensor: As an oxygen sensor, it offers high quality and reliability.
- Wide Fitment Compatibility: It is a direct replacement part suitable for multiple positions (upstream, downstream, sensor 1, sensor 2).
- Multi-function Design: It is a heated sensor that provides accurate and reliable output signal range (0.2V to 0.8V) to meet the vehicle's needs.
- Strong Compatibility: It has multiple interchange part numbers, ensuring compatibility with other related components.
Note:
Only defective sensors tested with a voltmeter are covered under the manufacturer's warranty.
A 20% restocking fee applies if the wrong items are purchased due to inattention to fitment information.
If the Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, use a voltmeter to test the sensor.
Further diagnosis is required if the sensor is good as there may be other functional failures not relevant to the sensor.
Installed, altered, or contaminated items are non-returnable.
Product Specifics
- Type: Oxygen Sensor
- Warranty: 1 Year
- UPC: 601209318769
- Interchange Part Number: o2 sensor cost, 02 sensors, heated oxygen sensor car
- Other Part Number: ES20197A
- Superseded Part Number: 15510-A
- Custom Bundle: No
- Modified Item: No
- Number of Pieces: 1
- Fitment Type: Direct Replacement
- Thread Size: M18
- Terminal Type: Blade
- Universal Or Specific Fit: Specific
- Attachment Method: Screw-On
- Connector Gender: Female
- Wire Harness Length: 22.83 IN
- Sensor Type: Heated
- Wire Quantity: 4
- Output Signal Range: 0.2V To 0.8V
- Mounting Type: Threaded
- Pin Quantity: 4
- Position: Upstream, Downstream, Sensor 1, Sensor 2
Includes
1 x Oygen O2 02 Sensor
As shown in the picture.
Installation
1. Remove any heat shield attached to the sensor by loosening the mounting bolts.
2. Use a regular socket to remove the sensor while avoiding damage to the sensor body and threads.
3. Disconnect the wiring connector before removing the sensor, if still attached.
4. Ensure that the wiring harness connectors match and configure the new sensor if necessary.
5. Clean the threaded port with a wire brush and carefully install the new sensor by hand, avoiding bending the wiring.
6. Tighten the sensor snugly to prevent leakage.
7. Reinstall any heat shields or bracing that were removed.
8. Mount the connector to its holder, reattach the connector to the wiring harness, and clear any diagnostic trouble codes if necessary.
